How to stretch the strings on the guitar?
The real skill of the guitarist is not evaluatedonly a qualitative reproduction of melodies, but also the ability to monitor it, and maintain your instrument. Our article will help novice musicians and tell you how to change the strings on the guitar.
How to remove old strings
The replacement procedure involves removing old stringsand installation of new ones. You can remove them in several ways. For example, immediately weaken all old strings and shoot them in turn. This allows you to evenly distribute the load on the neck. You can change one after another, first remove the old string, and in its place, install a new one, and so from the first to the sixth.
Nylon or metal
The classical six-stringed guitar hashorizontal arrangement of the pike mechanics and horizontal holes in the stand (rod-string holder). This guitar is designed mainly for nylon strings. Metal is rarely installed on a classical guitar, as reinforcement is required, otherwise damage can not be avoided. Nevertheless, the material does not significantly affect how to stretch the strings on the guitar, there will simply be small features when fastened in a string holder.
Arrangement of strings on guitar pins
It is convenient to work with the tool when it lies on theThe horizontal surface is supported by the deck, and the neck is slightly raised. To work you will need a set of strings and a guitar. The position of the strings and their fastening on the pins are as follows. In the right row: the nearest peg takes the first string, the middle one - the second one, the far one - the third one. In the left row: the nearest - the sixth, the middle - the fifth, the far - the fourth. This allows the tuned strings not to interfere with the installation of others.
Installation of nylon strings in the stand
We offer the following recommendations how to changestrings on the guitar. We begin with fastening of a string on a support (a thin plate on the case of a guitar - a string holder). The nylon string does not have a special shank, like a metal one, so it is necessary to fasten it to the stand with a knot.
The node is formed simply - it is necessary to push itstring into the hole, wrap the tail from either side of the base and thread into the loop. In this procedure there are little secrets. The first and second string must be secured more reliably, since the strings are thin and slippery. To do this, there must be a knot at the end of the string that, when forming the loop, will jam on the edge of the guitar stand.
Fastening strings on pins
The sequence of placing strings in pegs is notis fundamental. For convenience, start from the first to the sixth. The main thing is to observe the scheme for placing strings in pins. Keep the string under tension so that the knot on the stand does not loosen. It is threaded into the hole of the shaft of the spike and the free end wraps around itself. Then start twisting the pegs and winding the string. It should wind on the shaft along with its tail. The overlap of the string itself and its tail fixes it on the shaft. Enough 2 overlaps.
In order not to cause a strong distortion of the strings,After fixing them on the shaft of the spike, the direction of winding should be as follows. The first and sixth strings to the edges of the neck, the second, third, fourth and fifth to the center of the neck. Also, you must ensure that the wound strings do not rest against the body of the neck. This is the correct replacement of the strings on the guitar. The remaining long tails of strings should be removed.
Having studied the algorithm of the process, how to put strings onguitar, get down to practice. All the key steps need to be done with one string, only then go to the next one, otherwise everything will get confused and you will lose time.
It is necessary to carefully install each stringon a stand and pins. Hinges and winding must be tight and neat, this will facilitate a quick tuning process. The new strings will first stretch, so the tuning procedure will be carried out in stages.