How to connect an electric guitar to a computer - simply and quickly!
Many beginning musicians, having played the right time on an acoustic guitar, switch to electricians.And if life did not give them rich dad,face one small problem. An electric guitar without a pile of expensive and not very equipment is not an electric guitar at all, but a soundless instrument. You need to buy a lot, recording at the studio is expensive, and money from the fans of garage music is usually not very special. However, there is a way out, and we will now tell you how to connect an electric guitar to a computer. You can get any result immediately and for free. In addition, your digitized song will allow you to mock it with the help of various software - add a rhythm section and even the effect of having a lamp preamp.
How to connect an electric guitar to a computer?Yes, it's very simple!The cord has two ends - one in the guitar, the other in the jack-minijack adapter. And the adapter is in the blue entrance of the sound card. Some will say that even with a pink microphone input it can work, but no. The level of the blue entrance is much higher than the pink one (microphone). I will not go into details, but most likely this is due to the difference in the frequency range of the voice and various sound sources. In our case this is an electric guitar.
How to connect an electric guitar to a computer,hardware like sorted out, now the time of the program part. Theoretically, the guitar can already sound from the speakers. In Windows there is a mixing console - there are set volume levels for everything, it can happen that the line input, where the guitar is stuck, is off, or the settings are at a minimum. Then, accordingly, the guitar on the computer will not sound. By the way, advice on loudness. Want a clean sound, put it louder, you want to emulate the processor, put a smaller one. This rule is due to the fact that almost every effect has Gain (gain).
The volume level should be set so thatThe slider limited the sound index, not allowing him to enter the red zone. Also for comfortable work you will need ASIO4ALL drivers - they weigh very little and quietly swing from the official site. Do not be afraid of some terrible configuration - everything is simple. In addition, when you figure out how to connect an electric guitar to a computer, you will be waiting for a prize - an opportunity to play using software from the world's leading brands with a bunch of pre-adjustments and any useful and pleasant trivia. However, I will make a reservation: if you have a built-in audio card, it will not work. Do not worry, there will be no sound distortion, but there will be a sufficiently long delay time due to signal processing by the card itself.
This, of course, is not fatal, you just have toplay from memory what you do not yet hear. However, it's better to go to the store and choose a good sound card. This is the only serious waste.
By the way, do not look at the store with hungry eyeson ultra-expensive devices with ultra-high-super-superstores, they are not needed for now. It may well be a card for 10-30 bucks. Well, if you are already a happy owner of a good sound card, then please - Guitar RIG!
At your service the technology of emulation of the lampsound Dynamic Tube Response with saved pre-tunes pile of wonderful tube amplifiers, built-in tuner, effects and many professional tools.
As you can see, it's quite easy to connect an electric guitar to a computer.